100 per Box CONFAST 5/16 x 1-1/2 Hex Sleeve Anchor Zinc Plated
CONFAST 5/16' x 1-1/2' Hex Sleeve Anchor Zinc Plated (100 per Box): Industrial & Scientific. CONFAST 5/16" x 1-1/2" Hex Sleeve Anchor Zinc Plated (100 per Box): Industrial & Scientific. Applications.The anchor is made from Carbon Steel, and is Zinc Plated. This anchor is designed for use in Concrete, Block, and Brick..Environment.The anchor is designed for use in a Dry environment..Head Style .The anchor is a Hex head and is designed to allow the head to sit on top of the surface of the item being attached..Hole Diameter/Bit Diameter.The anchor requires a /6" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill..Diameter of Anchor .The diameter of the anchor is /6"..Length Anchor .The length of the anchor is -/".Minimum Embedment.The minimum anchor embedment into the concrete is ". Therefore, the anchor must be installed so that a minimum of " of the anchor is embedded into the concrete..Maximum Fixture Thickness.The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is /". This will ensure that the minimum embedment of " will be met..Fixture Hole Diameter.The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The /6" diameter anchor requires the hole in the fixture to be 3/8"..Spacing between Anchors.Each anchor must be spaced a minimum distance of 3-/8" from each other when measured center to center..Edge Distance.It is very important not to install the anchor any closer than -9/6" from an unsupported edge of the concrete.. . . .